Attaching Belt Loop System - Datamax APEX 3 User Manual

1.4 Attaching Belt Loop System

The belt loop system consists of two parts:

A knob located on the back part of the printer just above the battery door

A strap with a click-on connector
To attach the strap to the knob, insert the knob located at the bottom of the printer into the slot
of the connector. Pull down until a click is heard. The printer is now secure. The loop is then
placed over your belt to allow the printer to hang from either the left or right hip.

To release the printer, press inward on the two connector latches and pull the knob clear
of the slot.
Note: Do not force or pull the printer from the connector without pressing inward
on the two latches.
FIGURE 5: KNOB CONNECTION AND QUICK CLIP
6