Settings / Network; Ipv4 - D-Link DIR-615/X User Manual

DIR-615 Wireless N300 Router
User Manual

Settings / Network

To configure the router's local interface, go to the Settings / Network page.

IPv4

Go to the IPv4 tab to change IPv4 address, configure the built-in DHCP server, or specify MAC
address and IP address pairs.
Figure 82. Configuring the local interface. The IPv4 tab. The Local IP Address section.
Parameter
Mode of local IP
address assignment
IP address
Mask
Gateway IP address
Hostname
Local IP Address
Available if the Access point, Repeater, or Client mode was
selected in the Setup Wizard.
Select the needed value from the drop-down list.
Static: The IP address, subnet mask, and the gateway IP
•
address are assigned manually.
Dynamic: The
•
parameters from the LAN DHCP server or from the router to
which it connects.
The IP address of the router in the local subnet. By default, the
following value is specified: 192.168.0.1.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Available if the Access point, Repeater, or Client mode was
selected in the Setup Wizard.
The gateway IP address which is used by the router to connect to the
Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
The name of the device assigned to its IP address in the local subnet.
Page 96 of 176
Configuring via Web-based Interface
Description
router automatically obtains these