Checks Before Installation - Hoshizaki DCM-500B H Instruction Manual

B. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the appliance,
it will not work properly.
• See the nameplate on the rear panel, and check that your voltage supplied corresponds
with the voltage specified on the nameplate.
• Remove the panels to prevent damage when installing the appliance. See "II.C. How to
Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the appliance is exposed to the
sun or to heat, remove the film after the appliance cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• This appliance can be installed on a countertop or on an optional stand. If using an
optional stand, see the table below. For further options, contact your local Hoshizaki
distributor.
Model Number
DCM-300BAH(-OS)
DCM-500B_H(-OS)
DCM-751BWH(-OS)
DCM-752BAH(-OS)
• The drip tray on the front of the DCM-751BWH(-OS) and DCM-752BAH(-OS) is
removable for installations using an in-counter drain. Drip tray removal requires
HS-5003 for DCM-751BWH and DCM-752BAH or HS-5002 for DCM-751BWH-OS
and DCM-752BAH-OS.
DCM on Hoshizaki Stand
SD-450 or SD-700
SD Stand
SD-450/SD-500
SD-700/SD-750
DCM on Hoshizaki Stand
SD-500 or SD-750
DCM-751BWH and
DCM-752BAH with
Drip Tray Removal Kit
HS-5003
Model Shown: DCM-752BAH
13
DCM-751BWH-OS and
DCM-752BAH-OS with
Drip Tray Removal Kit
HS-5002