Hoshizaki DCM-500B H Instruction Manual page 27

Cubelet icemaker/dispenser
Table of Contents

Advertisement

7) Replace spout A, spout B, and the ice storage bin cover in their correct positions.
8) Allow the icemaker to sit for 10 minutes before operation. If you placed a clamp on the
reservoir hose in step 6, remove it before operation.
9) In bad or severe water conditions, clean the float switch assembly as described below.
Otherwise, continue to step 10.
a. Remove the float switch assembly from the reservoir cover.
b. Wipe down the float switch assembly with the cleaning solution.
c. Rinse the float switch assembly thoroughly with clean water.
d. Replace the float switch assembly in its correct position.
10) Move the power switch to the "ON" position and replace the panels in their correct
positions. Turn on the power supply, then move the control switch to the "ICE" position.
Make ice using the solution until the icemaker stops making ice.
Note: This unit will not run if the safety switch is not engaged.
11) Move the control switch to the "OFF" position, pause momentarily, then move to the
"DRAIN" position. Allow the water system to drain for 5 minutes.
12) Move the control switch to the "OFF" position, pause momentarily, then move to the
"ICE" position. Open the icemaker water supply line shut-off valve to supply water to the
reservoir.
13) After the gear motor starts, move the control switch to the "OFF" position, pause
momentarily, then move to the "DRAIN" position. Allow the water system to drain for
5 minutes.
Note: If you do not sanitize the unit, move the control switch to the "OFF" position,
pause momentarily, then move to the "ICE" position after the water system drains.
Allow the icemaker to run for 30 minutes, then move the control switch to the
"OFF" position. Turn off the power supply, then remove the front panel and ice
storage bin cover. Move the power switch to the "OFF" position. Go to step 12 in
"III.B.2.c) Cleaning and Sanitizing Procedure."
14) Move the control switch to the "OFF" position, then turn off the power supply.
15) Close the icemaker water supply line shut-off valve.
27

Advertisement

Table of Contents
loading

Table of Contents