Checks Before Installation; Icemaker; Remote Condensing Unit - Hoshizaki SRK-15J Instruction Manual

B. Checks Before Installation
• Visually inspect the exterior of the shipping containers and immediately report any
damage to the carrier. Upon opening the containers, any concealed damage should
also be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the icemaker
or remote condensing unit, they will not work properly.

1. Icemaker

• Remove the panels to prevent damage when installing the icemaker. See "II.C. How to
Remove Panels." NOTICE! Leave the front frame in place until "II.D.2 Water Tank
Removal."
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the icemaker is exposed to the sun
or to heat, remove the film after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces.
• This icemaker can be installed on a dispenser unit or storage bin 30" wide or wider.
For options, contact your local Hoshizaki distributor.
• NOTICE! This icemaker is designed for connection to Hoshizaki Remote
Condensing Unit Model SRK-15J or SRK-15J3 only! CONNECTION TO ANOTHER
REMOTE CONDENSING UNIT WILL VOID WARRANTY.

2. Remote Condensing Unit

• See the nameplate on the remote condensing unit. Check that your voltage supplied
corresponds with the voltage specified on the nameplate.
• Remove the panels to prevent damage when installing the remote condensing unit.
See "II.C. How to Remove Panels."
• Remove the package containing the accessories.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blades turn freely.
• Check that the compressor is snug on all mounting pads.
11