Hoshizaki DCM-500B H Instruction Manual page 29

3) Remove the ice storage bin cover.
4) Remove the motor bracket thumbscrews, first from the vertical plane and then from the
horizontal plane. While holding on to the corresponding agitator or auger, move the
agitating motor or the dispensing motor towards you. Remove the agitator(s) and the
dispensing auger from the ice storage bin. See Fig. 9.
Note: DCM-300 and DCM-500 models have 1 agitator and DCM-751 and DCM-752
models have 2 agitators.
5) Remove the bin control assembly. See Fig. 10.
6) Remove the snap pin, shaft, and actuator.
7) Remove spout B, spout A, and their gaskets.
8) Remove the spout cover, ice dispensing spout, and water dispensing nozzle. See
Fig. 11. On DCM-751 and DCM-752 models, also remove the ice guide, drain pipe
holder, and drain pipe from the ice storage bin. See Fig. 9.
9) Immerse the agitator(s), dispensing auger, and parts removed in steps 5 through 8
in the cleaning solution for 15 min. Rinse the parts thoroughly with clean water, then
immerse the parts into the sanitizing solution for 15 min. Rinse the parts thoroughly with
clean water. On optical sensor models (-OS), wipe the optical sensors with cleaning
solution and then with a clean, damp cloth.
10) Wipe the shutter located above the ice dispensing spout thoroughly with a clean cloth.
11) Reassemble the bin control assembly and replace all parts in the reverse order of which
they were removed.
12) Pour warm water into the ice storage bin and melt any remaining ice. Clean the ice
storage bin liner and the ice storage bin cover using a neutral cleaner. Rinse thoroughly
after cleaning. Replace the ice storage bin cover in its correct position.
13) Move the power switch to the "ON" position, then replace the panels in their correct
positions. Turn on the power supply, then move the control switch to the "ICE" position
to start the automatic icemaking process.
Snap Pin
Shaft
Actuator
Fig. 10
Bin Control Bracket
29
Water Dispensing Nozzle
Ice Dispensing Spout
Spout Cover
Fig. 11