Remote Control - Yamaha RX-SL80 Owner's Manual

TROUBLESHOOTING
The desired station
cannot be tuned in with
the automatic tuning
method.
There are continuous
crackling and hissing
noises.
AM
There are buzzing and
whining noises
(especially in the
evening).

Remote control

Problem
The remote control
does not work or
function properly.
54
The signal is weak or the antenna
connections are loose.
Noises result from lightning,
fluorescent lamps, motors,
thermostats and other electrical
equipment.
A TV set is being used nearby.
The AM loop antenna is placed near
the speaker cables.
The AM ANT and GND cords are
inserted in the wrong terminal.
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The remote control code was not correctly
set.
Even if the remote control code is
correctly set, some models may not
respond to the remote control.
Tighten the AM loop antenna connections
and orient it for best reception.
Use the manual tuning method.
Use an outdoor antenna and a ground wire.
This will help somewhat, but it is difficult to
eliminate all noise.
Move this unit away from the TV.
Place the AM loop antenna away from the
speaker cables.
Make sure the white cord is inserted into the
AM ANT terminal and the black cord into
the GND terminal.
Remedy
The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
Set the remote control code correctly.
Try to set the other codes of the same manufacturer.
—
23
—
—
—
14
Refer to
page
6
—
3
47
47