Input Menu - Yamaha RX-SL80 Owner's Manual

Dynamic range
F)DYNAMIC RANGE
Use to select the amount of dynamic range compression to
be applied to your speakers or headphones. This setting is
effective only when the unit is decoding Dolby Digital and
DTS signals.
Choices: MIN (minimum), STD (standard),
MAX (maximum)
F)DYNAMIC RANGE
. SP: MIN STD)MAX
HP: MIN STD)MAX
[ ]/[ ]:Up/Down
[<]/[>]:Select
Speaker SP
Select to adjust the speaker compression.
Headphone HP
Select to adjust the headphone compression.
• Select MIN if you regularly listen at low volume levels.
• Select STD for general use.
• Select MAX to preserve the greatest amount of
dynamic range.
Audio set
G)AUDIO SET
Use to customize this units overall audio settings.
G)AUDIO SET
. AUDIO MUTE;;MUTE
AUDIO DELAY;;0ms
[ ]/[ ]:Up/Down
[<]/[>]:Selet
Audio mute AUDIO MUTE
Use to adjust how much the mute function reduces the
output volume.
Choices: MUTE, –20 dB
• Select MUTE to completely halt all output of sound.
• Select –20 dB to reduce the current volume by 20 dB.
Audio delay AUDIO DELAY
Use to delay the sound output and synchronize it with the
video image. This may be necessary when using certain
LCD monitors or projectors.
Choices: 0 to 160 ms

2 INPUT MENU

Use this menu to manually adjust any input setting.
2 INPUT MENU
. A)INPUT ASSIGN
B)INPUT MODE
[ ]/[ ]:Up/Down
[ENTER]:Enter
Input assignment
You can assign jacks according to the component to be
used if this unit's initial settings do not correspond to your
needs. Change the following parameters to reassign the
respective jacks and effectively connect more components.
Once the inputs have been reassigned, you can select the
corresponding component by using INPUT on the front
panel or the input selector buttons on the remote control.
For OPTICAL INPUT jacks 1 and 2
Choices: DVD/CD, VIDEO1, VCR, DTV/CBL
OPTICAL IN
. (1);;;;; DVD/CD
(2);;;;;DTV/CBL
Note
OPTICAL IN(2) cannot be assigned to an item already set to
OPTICAL IN(1). If you want to assign OPTICAL IN(2), change
the selection for OPTICAL IN(1). If the above settings are
incorrect, "– – –" appears in the display.
For COAXIAL INPUT jack 3
Choices: VIDEO1, VCR, DTV/CBL, DVD/CD
COAXIAL IN
. (3);;;;; VIDEO1
Note
COAXIAL IN(3) cannot be assigned to an item already set to
OPTICAL IN(1) or OPTICAL IN(2). If you want to assign
COAXIAL IN(3), change the selection for OPTICAL IN(1) or
OPTICAL IN(2). If the above settings are incorrect, "– – –"
appears in the display.
SET MENU
A)INPUT ASSIGN
( DVD/CD )
(DTV/CBL )
( VIDEO1 )
43