Yamaha MM1242 Operation Manual page 6

5 PAN control
The PAN control determines the position in the stereo
sound field at which the sound from that channel is heard,
by distributing signal from each channel to STEREO L
and R buses.
6 PEAK indicator
The PEAK indicator LED lights in red when the pre-EQ,
post-EQ, or post-fader signal of the corresponding
channel's input reaches a level 3dB below the clipping
level.
7 PFL switch
Press this switch to monitor the pre-fader input channel
signal through the MONITOR OUT or the PHONES
connector.
This is useful when you wish to monitor only the signal
MIC IN
1-12
LINE IN
1-12
PHANTOM
OFF
(+48V)
ON
(MIC IN)
PHANTOM
(PHANTOM)
HA
HA BA
LINE
GAIN
MIC
from a particular channel, or take a countermeasure for a
problem.
8 Fader
This is the main level control for each input channel. It de-
termines the level of the signal sent from the
corresponding input channel to the master stereo bus. The
settings of the input channel faders determine the "mix" or
balance of sound levels between the instruments or other
sources connected to the inputs.
Lower the faders of unused channels to the bottom.
PEAK
EQ BA BA
(+V)
PAN
AUX 1
AUX 2
AUX 3
AUX 4
PFL
3