Yamaha MM1242 Operation Manual page 8

0 PHONES jack
Connect the headphones here.
You can monitor the following signals:
— Signals available for monitoring —
1. Post-EQ signal
(when the corresponding channel PFL switch is ON)
2. Pre-fader ST signal
(when the corresponding stereo L/R PFL switch is ON)
3. Pre-AUX SEND 3/4-fader signal
(when the corresponding AUX send 3/4 PFL switch is
ON)
SUM INV
(+V)
PFL
SUM INV
(+V)
PFL
SUM
SUM
(+V)
(ST OUT)
PFL
+
SUM
SUM INV
+
SUM
A MONITOR control
This control adjusts the level of the signal output from the
MONITOR OUT.
B PHONES LEVEL control
The PHONES control adjusts the level of the signal sent to
the PHONES jack.
C AUX SEND 3, 4 PFL switches
Turning this switch ON will allow you to monitor the
signal output to AUX SEND 3 and 4 via the MONITOR
OUT or headphones.
D AUX SEND 3, 4 faders
These faders adjust the AUX SEND 3 and 4 output levels.
You can also use these to adjust the level of an auxiliary
output.
METER
(MONITOR)
STEREO OUT
METER
(MONITOR)
INV
AUX SEND 1
METER
INV
INV
MONITOR
INV
INV
LEVEL
INV
L
+4dB
R
AUX SEND
1,2 +4dB
AUX SEND
3,4 +4dB
L
MONITOR
OUT +4dB
R
PHONES
5