To reset the device to factory defaults, insert a
straightened paperclip into the Reset hole to press the
button. Keep pressing and power cycle (off and on) the
device. Wait for at least 5 seconds to release the button.
Then wait for the device to finish booting.
If you want to restore your customized settings after loading
defaults, refer to "4.8 Administration" for more information.
2.2 Hardware Connection
Choosing a Place for the Router
•
Place the device close to the power outlet for the cable to
reach it easily.
•
Avoid placing the device in places where people may walk
on the cables. Also keep it away from direct sunshine or
heat sources.
•
Place the device on a flat and stable stand.
Connecting the Wireless Broadband Router
Prior to connecting the hardware, make sure to power off your
Ethernet device, Cable/ADSL modem and Wireless Broadband
Router. Then follow the steps below to connect the related devices.
Step 1 Connecting Your PC to the LAN port.
Attach one end of the Ethernet cable with RJ-45
connectors to your hub, switch or a PC's Ethernet port,
and the other end to one of the LAN ports of your
Wireless Broadband Router.
Step 2 Connecting Cable/ADSL Modem to the Internet/WAN
port.
Connect the Ethernet cable attaching to your Cable/ADSL
modem to the Internet/WAN port of your Wireless
Broadband Router.
Step 3 Connecting the power adapter.
2. Hardware Description & Installation