Advertisement
Congratulations! You are now at your Router's dashboard. Your
Router is set up and ready to use.
Using the WPS Button
1) Start WPS Push Button Connection (WPS PBC) on your
computer or other Wi-Fi device that you would like to
connect wirelessly to your Router. Often there will be a
button for this purpose in software that came with the device,
or a physical "WPS," "PBC," or "Security" button on the device
itself.
2) Within two minutes, press the WPS button on your Router
and hold for two seconds.
The WPS light (small light above WPS button) will blink blue
while it listens for your Wi-Fi device. Once a connection is
established, the light will turn blue and then go out. If a
connection is not established, the light will blink amber. You
may repeat the process to try again.
You can repeat this process for each WPS-enabled device you'd
like to add to your network.
Manually Set Up Your Internet
Connection
Use a browser to visit http://router/. You can also try visiting http://192.168.2.1/. The
Router's Welcome page should appear.
Advertisement
