Setting Up Wireless Client - Belkin F5D7230-4 User Manual

Checking/Renew IP Address under Windows 2000
To verify if your network adapter gets an IP address within the
DHCP IP pool range (192.168.1.100 ~ 192.168.1.150 by default) of
the router, follow the related description under Windows NT section.
The procedures are the same.

3.2 Setting up Wireless Client

You can also choose to access the router via a wireless client,
whether for configuration purpose or sharing network resource and
Internet connection. To get your wireless client connected to the
router, verify the following:
1. Make sure your PC is equipped with WLAN adapter and has
appropriate WLAN card driver/utility and TCP/IP installed.
2. Set the WLAN client to obtain a dynamic IP address from the
Wireless Broadband Router.
The procedures are the same as described above. The only
difference is that you are configuring the TCP/IP associated
with your Wireless LAN Card.
3. Verify that your WLAN setting is identical to the router's default
wireless settings:
•
Operation Mode: Infrastructure
•
SSID: Refer the default SSID of the device
•
Authentication: Open
•
WEP Mode: Disabled
3. Setting Up Ethernet/WLAN Client