Table of Contents
Advertisement
Recording
ªChecking the remaining
recording time
Press [MODE] while recording.
Press again to return to the
R e m a i n i n g
previous display.
recording time
The above display is shown automatically when the
remaining recording time becomes very short. Press
[MODE] to show the recording time in this case.
ªChecking the remaining
memory on the card
While the unit is stopped, press
and hold [STOP] for 2 seconds.
The meter reduces from right
Memory meter
to left as the remaining
memory reduces.
ªConnecting external microphone
Connect the microphone to the [MIC (PLUG IN
POWER)] jack. The built-in microphone is turned off.
1
Plug type: 3.5 mm (
/
in.) monaural
8
ªWhen a "NO MORE..." display appears
There are nine folders, there are 99 files in the folder,
or the card is out of memory.
Delete unneeded folders, and files or use another
card.
12
Changing microphone sensitivity
1To select
You can set sensitivity to high (to record relatively
softer sounds) or low (to record only relatively
P u s h
louder sounds) to suit the circumstances. The
up or
recording level meter can help you determine
down
which level is needed. The sensitivity also works if
you have connected external microphone.
This example shows how to set sensitivity to "HIGH".
2To confirm
1
Press [MODE].
selection
You can now select a mode.
Press
2
1 Within 10 seconds
2 Within 10 seconds
3
1 Within 10 seconds
2 Within 10 seconds
Push [SELECT, ENTER] up
or down so "MIC SENSE"
flashes.
Press [SELECT, ENTER].
Push [SELECT, ENTER]
up or down so "SENS
> H?" flashes.
Press [SELECT, ENTER].
"SENS=HIGH SET" is displayed.
Using the voice activating system to
prevent unnecessary recording
The digital voice activating system (VAS) pauses
recording during periods of silence and so prevents
recording unnecessarily. VAS works better when
microphone sensitivity is set to "LOW".
1
Press [MODE].
You can now select a mode.
2
1 Within 10 seconds
Push [SELECT, ENTER]
up or down so "VAS
SET" flashes.
2 Within 10 seconds
Press [SELECT, ENTER].
3
1 Within 10 seconds
Push [SELECT, ENTER] up or
down to select "VAS > ON?".
2 Within 10 seconds
Press [SELECT, ENTER].
"VAS=ON SET" is displayed and "
" lights.
ªTo turn VAS off
Select "VAS > OFF?" in step 3 and press [SELECT, ENTER].
Turn VAS off when making important recordings.
13
Advertisement
Table of Contents
