Table of Contents
Advertisement
Inserting the batteries
The battery indicator
The indicator is shown during operation.
Full
Low
Replace the batteries when the indicator starts
flashing.
Note
≥The unit indicates the batteries are low even
when there is still some life left in them. This is
to preserve the contents of the memory.
≥Replace the batteries within 30 seconds to
preserve the clock settings. Recordings remain
intact.
6
Hold function
This prevents accidental operation causing the
batteries to run down.
Hold
(Flashes)
When switched on
''HOLD'' appears for a few
seconds and then the display
goes out. Switch hold on
when not using the unit to
preserve the batteries.
Release hold before operation.
Setting the time
Set the time to keep track of when recordings were made. Start from step 2, 2 after inserting the
batteries. Reset the clock regularly to maintain accuracy. (Monthly accuracy i/j60 seconds)
1To select
Release
Push up
or down
2To
confirm
selection
Press
1
4
1 Within 10 seconds
Press [MODE].
You can now select a mode
(' page 9, "Selecting modes").
2
1 Within 10 seconds
Push [SELECT, ENTER] up
or down so "TIME ADJ"
2 Within 10 seconds
flashes.
2 Within 10 seconds
Press [SELECT, ENTER].
5
Using the operations described
The year display flashes.
in 1 and 2, set the time.
N o r m a l
display
3
Using
the
operations
ªIf the normal display appears
described in 1 and 2, set
before you finish
the year, month, and day.
Start again from step 1.
"12 H" flashes.
Note
The clock stops when you replace the
batteries but starts again when you insert
the batteries and close the battery cover.
Push [SELECT, ENTER] up
or down to select 12 or 24
hour display.
Press [SELECT, ENTER].
The time display flashes.
HQ
7
Advertisement
Table of Contents
