Advertisement
16.Do not use Kettle without the Lid in place.
17.Scalding may occur if Lid is opened while the Kettle is hot.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
GROUNDED PLUG
To reduce the risk of electric shock this appliance has a grounded plug
(2 blades and 1 pin). If the plug does not fit fully into the electrical outlet
contact a qualified electrician. Do not modify the plug in any way or use
an adaptor.
BEFORE FIRST USE
1. Read all instructions carefully and keep them for future reference.
2. Remove all packaging.
3. The Aquascreen® filter has been installed in the spout of the Kettle
during production. If it has been dislodged during shipping check
inside the Kettle or in the box. Install the Filter before using the
Kettle. See the instructions in the Care & Cleaning section.
IMPORTANT NOTES:
DO NOT remove or install the filter when the Kettle is hot.
DO NOT use the kettle without the filter in position:
- This may allow water to spit out when boiling
- The kettle may remain in the boil cycle too long once the water has
boiled
- The kettle may not shut off
4. Fill the Kettle with 1 litre (4 cups) of cold tap water and bring to a boil.
Add 500 ml (2 cups) of white vinegar and let stand for at least 1 hour
or overnight. Discard.
5. Fill the kettle to the maximum fill line with cold tap water. Bring to a
boil and discard. Repeat.
6. The kettle is ready to use.
HOW TO USE
1. Open the Lid. Fill the kettle through the lid opening with a minimum of
500 ml (2 cups) of water.
2. DO NOT attempt to fill the Kettle while it is plugged into the wall outlet.
DO NOT use for other than boiling water. Other liquids will
contaminate the interior of the kettle.
DO NOT fill past the MAX level indicated in the water level window.
Overfilling may cause water to spit out when boiling.
3
Advertisement
