Maintenance Schedule - Hoshizaki C-101BAH-DS Instruction Manual

A. Maintenance Schedule
The maintenance schedule below is a guideline. More frequent maintenance may be
required depending on water quality, the appliance's environment, and local sanitation
regulations.
Frequency Area
Weekly Scoop
Drain the Appliance Move the control switch to the "DRAIN" position. Allow the water system to
Monthly
Appliance Exterior
Every 3 Storage Bin Drain
Months
Every 6 Icemaker and
Months Storage Bin
Evaporator
Condensate Drain
Pan and Gear
Motor Drain Pan
Optional Drain
Pump (HS-5061)
External Water
Filters
Yearly Water Supply Inlet
Condenser
Water Hoses
Upper Bearing
(extruding head)
After Upper Bearing
3 Years, (extruding head);
then Yearly Lower Bearing
and O-Ring
(lower housing);
Mechanical
Seal; Evaporator
Cylinder; Auger

Maintenance Schedule

Task
Clean the scoop using a neutral cleaner. Rinse thoroughly after cleaning.
drain for 1 minute. Clear ice away from the thermostatic bin control bulb.
Move the control switch to the "ICE" position. After the gear motor starts,
move the control switch to the "DRAIN" position. Allow the water system to
drain for 1 minute. Move the control switch to the "ICE" position to start the
automatic icemaking process.
Wipe down with clean, soft cloth. Use a damp cloth containing a neutral
cleaner to wipe off oil or dirt build up. Clean any chlorine staining (rust
colored spots) using a non-abrasive cleanser.
Maintain as outlined in "IV.C. Storage Bin Drain."
Clean and sanitize per the cleaning and sanitizing instructions provided in
this manual. See "IV.B. Cleaning and Sanitizing Instructions."
Wipe down with clean cloth and warm water.
Evaporator
Condensate
Drain Pan
Gear Motor
Drain Pan
Test as outlined in "IV.E. Optional Drain Pump HS-5061."
Check for proper pressure and change if necessary.
Close the water supply line shut-off valve and drain the water system. Clean
the water supply inlet screen.
Inspect. Clean if necessary. See "IV.D. Condenser."
Inspect the water hoses and clean/replace if necessary.
Check for wear using .02" round stock or pin gauge. Replace both upper
bearing and lower bearing if wear exceeds factory recommendations. See
the Service Manual for details.
Inspect. Replace both upper bearing and lower bearing if wear exceeds
factory recommendations. Replace the mechanical seal if the seal's contact
surfaces are worn, cracked, or scratched.
31