Hoshizaki C-101BAH-DS Instruction Manual page 19

6) If you would like to reverse the door hinges, do the following:
a) Contact your local distributor to purchase Hoshizaki Kit HS-0229. The kit contains
"hinge (A)-left."
b) Remove the 2 bolts securing the top panel, then lift it off. See Fig. 11.
c) Remove hinge (A)-right and the bracket from the right side of the appliance. Set
aside hinge (A)-right; it is not needed. Remove the top brace from the left side.
Fasten hinge (A)-left and the bracket to the left side and the top brace to the right
side. See Fig. 12.
Note: When on the proper side, the gasket notch for hinge (A) is to the inside.
Bolts
Top Panel
Fig. 11
d) Remove hinge (B) from the right side of the appliance and the 2 filler screws from
the left side. Attach the 2 filler screws to the right side and attach hinge (B) to the
left side. See Fig. 13.
e) Rotate the top panel 180° from its previous position. This brings the notch that was
previously in the right rear to the left front. See Fig. 14. Hook the rear part of the
panel on the body, then secure the front with the 2 bolts removed in step 6a.
Screws
Hinge (B)
Filler
Screws
Fig. 13
f) Remove hinge (C1) from the top right part of the door, flip it and reattach to the
bottom left. Remove hinge (C2) from the bottom right part of the door, flip it and
reattach to the top left. See Fig. 15. Proceed to step 7.
Fig. 15
Hinge (A)-Left
Screws
Hinge (C2)
Hinge (C1)
Screws
19
Bracket
Gasket Notch
Fig. 12
Top Panel
Fig. 14
Screw
Screw
Top Brace
Hinge (A)-Right
Not Needed
Notch