Adjusting The Anti-Scalp Rollers; Using Attachments And Accessories - Toro TimeCutter HD ZX5400 Operator's Manual

3. Select a hole in the height-of-cut system
corresponding to the desired height of cut and
insert the pin (Figure
4. Push on the deck-lift pedal with your foot and
pull the handle rearward to disengage the
transport lock (Figure
5. Lower the deck slowly until the lever makes
contact with the pin.
Figure 26
1. Deck-lift pedal
2. Handle
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake; refer to Engaging the Parking Brake
(page 18).
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
27.
26).
25).
3. Pin
4. Height-of-cut positions
Figure
1. Anti-scalp roller
2. Spacer
3. Bushing
Using Attachments and
Accessories
Use only Toro approved attachments and accessories.
g188850
If you attach a bucket to the engine guard, use a strap
to secure it.
Important:
The bucket weight impacts the
stability of the machine. If you are carrying more
than the weight listed in the table below in a
bucket attached to the engine guard, you must
equip your machine with the Bucket-Support Kit.
Contact your Authorized Service Dealer.
Model
48-inch deck
54-inch deck
60-inch deck
24
Figure 27
4. Flange nut
5. Bolt
Maximum weight per bucket
without the Bucket-Support
Kit
1.1 kg (2.5 lb)
1.1 kg (2.5 lb)
4.5 kg (10 lb)
g029955