Pushing The Machine By Hand - Toro TimeCutter HD ZX5400 Operator's Manual

and loss of control. Reduce the towed weight and
slow down.
•
Stopping distance increases with the weight of the
towed load. Travel slowly and allow extra distance
to stop.
•
Make wide turns to keep the attachment clear of
the machine.
Pushing the Machine by
Hand
Important:
Always push the machine by hand.
Do not tow the machine, because towing may
damage it.
This machine has an electric-brake mechanism,
and to push the machine, the key must be in the
position. The battery needs to be charged and
RUN
functioning to disengage the electric brake.
Pushing the Machine
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Locate the bypass levers on the frame on both
sides of the engine.
4. Move the bypass levers forward through the key
hole and down to lock them in place
Note:
Do this for each lever.
5. Turn the ignition key on and disengage the
parking brake.
Note:
Do not start the machine.
1. Bypass-lever locations
2. Lever position for
operating the machine
6. When finished, ensure that the key has been
returned to the
the battery charge.
Operating the Machine
Move the bypass levers rearward through the keyhole
and down to lock them in place as shown in
(Figure 31).
Note:
28
Figure 31
3. Lever position for pushing
position to avoid draining
STOP
Do this for each lever.
g207190
the machine
Figure 31.