Using The Smart Speed Tm Control System - Toro TimeCutter HD ZX5400 Operator's Manual

Figure 22
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion-control
levers rearward (Figure
Figure 23
g008952
23).
g008953
Using the Smart Speed
Control System
The Smart Speed TM
below the operating position
operator a choice to drive the machine at 3 ground
speed ranges-trim, tow, and mow.
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and
outward to the P
2. Disengage the blade-control switch.
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments vary by grass type, moisture content,
and the height of the grass.
Trim
Suggested
uses:
Parking X
Heavy, wet X
grass
Training X
Trimming X
grass
Bagging
Mulching
Towing
attachments
Normal
mowing
Moving the
machine
Trim
This is the lowest speed. The suggested uses for this
speed are as follows:
•
Parking
22
Control-System lever, located
(Figure 24), gives the
Figure 24
position.
ARK
Tow Mow
X
X
X
X
X
TM
g027625