Speco D16HT User Manual page 83

channel.
o FRAME RATE: Sets the recording rate.
o QUALITY: Sets the image quality in 5 levels.
o RECORDING MODE: Sets the recording mode.
o RECORD DAYS: By the setting value, the Recording Days will change accordingly.
7-7-4. Device
Select Device to set Spot Out, Enable/Disable CVBS Out, motion zone.

ALARM OUT: Set the sensor, motion, and video loss for triggering alarm relay.
HDD Error and Video Loss can be set for triggering a beeping sound
The following settings can be changed to trigger an alarm output.
o ALARM DURATION

DIGITAL DETERRENT: The schedule of digital deterrent can be set and a sound file can be
uploaded to the HT.
To set up schedule, select CHANNEL > select SOUND TYPE > select Area.

CONTROLLER: Set the controller baud rate and ID.

PTZ: Set the PTZ baud rate, protocol, and ID.

SPOT OUT:
o
SPOT ON EVENT: Enable/disable channel change if an event occurs on a channel
o
SEQUENCE: Enable/disable sequential display of spot channel in full screen
o
SPOT CHANNEL: Select a channel for spot monitoring using the mouse or the remote control
and press OK button

MOTION: Setup the motion detection area and the sensitivity.
o
SITE: Select the channel
o
MOTION ZONE: FULL Zone or PARTIAL Zone
o
MOTION SENSITIVITY: 1~9 (High sensitivity level)
83