Speco D16HT User Manual page 82

o MOTION DETECTION : Enable Email Notification when the camera detects motion
o VIDEO LOSS: Enable Email, Beep and Alarm output Notification when the camera signal is
lost.
o HDD TEMPERATURE : Enable Email Beep and Alarm output Notification when the HDD
reaches the maximum temperature
o HDD BAD SECTOR: Enable Email Notification when the HDD has bad sectors.
o HDD ALMOST FULL: Enable Email Notification when the HDD is almost full.
o HDD FULL: Enable Email Notification when the HDD is full.
o HDD FAILURE: Enable Email, Beep and Alarm output Notification when the HDD fails.
7-7-3. Record
Select RECORD tab to set the recording conditions.
These settings apply to the specified channel only.

Recording Setup
o RESOLUTION: Sets the resolution for the recordings. The set value applies to an individual
channel.
o FRAME RATE: Sets the recording rate.
o QUALITY: Sets the image quality in 5 levels.
o RECORDING: Sets the recording mode.
o RECORDING MODE: CONTINUOS, SCHEDULE, MOTION, SENSOR
o PRE RECORD: Sets whether to perform or not pre-recording.
o POSE EVENT RECORD: Sets the duration of the event recording.
o AUDIO: Sets whether to perform or not audio recording.
o SECHDULE: Sets the schedule recording.
These settings apply to all channels.

EZRECORD
o RESOLUTION: Sets the resolution for the recordings. The set value applies to an individual
82