How To Attach The Pad - Omron HVF-F127 Instruction Manual

Place the Pad on a flat surface and securely connect the Electrode Cord Plug
with the Pad.
❇ Although Electrode Cord Plugs are provided in red and white, either plug can
be connected with one of the Pads irrespective of color.
General advice from OMRON on the handling of Electrode Cord
• Avoid excessive bending and pulling of the Electrode Cord.
• Hold the Electrode Cord Plug when unplugging the Electrode Cord from the Main Unit.
• If the Electrode Cord is torn or in trouble, please contact the store where you purchased the unit or at the
nearest OMRON dealer.

How to Attach the Pad

Attach each Pad to the region you want to treat without bending it.
When you use the unit for the first time:
A clear plastic film is attached to the Pad.
As the Pad has strong adhesiveness, peel off the clear plastic film from the
Pad and attach the Pad to the region you want to receive treatment.
❇ Discard the peeled off clear film as it should not be used anymore.
❇ It may be difficult for you to attach the Pad on your back such as shoulders or lower
back. It is a good idea to ask someone in your family to help you.
Attach the Pad close to the skin.
❇ If the Pad comes off from the skin, the unit is turned off automatically in approximately 7 seconds.
General Advice from OMRON on the handling of Pad
• Do not place pads one on top of the other.
• Do not bend the Pad.
• Do not touch the adhesive surface with your fingers.
• When you perspire after taking a bath or immediately after exercising, wipe your sweat off the region you
want to treat before using the unit.
• If the Pad is erroneously adhered to a cloth or so and does not come off easily, do not force to peel it off.
Instead, moisten the back of the cloth to which the Pad is attached with a small amount of water, and then
the Pad will come off easily.
• When the adhesive property of Pad drops, take appropriate measures as necessary.
• If you are going to use a wet Pad or the Pad immediately after it is washed, let it dry sufficiently. Especially
let the adhesive surface air-dry.
8