Table of Contents
Advertisement
Registering Contacts for Network Folder or FTP Scanning - Web Config
You can register a list of contacts for scanning to a network folder or FTP server using Web Config and
your computer's internet browser.
Before you begin, print a network status sheet and locate the IP address for your product on the sheet.
Note: These instructions use Internet Explorer as an example browser.
1. Start Internet Explorer on a computer that is using the same network as your product.
2. Type your product's IP address into the address bar and press Enter.
3. Click Continue to this website (not recommended).
4. Click Contacts.
5. Select the number you want to use for the contact you are adding and click Edit.
6. Select Network Folder (SMB) or FTP as the Type setting.
7. Enter the following information for the contact:
• Name: The name to display in your product's contact list.
• Index Word: Enter a word to identify this entry when searching for it (up to 30 characters). This
field is optional.
• Save to: The network path to the shared folder.
Enter the folder path name in one of the following formats depending on the Type setting you
selected:
• SMB: host_name\folder
• FTP: host_name/folder_name
• User Name and Password: Enter only if you have set up a password on your computer.
• Connection Mode: For FTP locations, select Passive Mode if there is a firewall between the
product and FTP server.
• Port Number: For FTP locations, enter the port number.
8. Click Apply.
After a moment, you see a message telling you that contact registration is complete.
9. Close your web browser.
Parent topic:
Setting Up and Scanning to a Network Folder or FTP Server
151
Advertisement
Table of Contents
