Table of Contents
Advertisement
10. PROGRAMMING PROCEDURES
10.11 PRINT FORMAT
Menu Page: 2
Item No.:
0
The SL-9000 can memorize 5 different print formats. After print formats are set, you can call them by
pressing the print format number.
<MENU>
Page 2
CHANGE
Issue method
PLU
Batch
Select the Item for
adjustment.
1 gradation
=0.154 mm (1 dot)
1 gradation
=0.462 mm (3 dots)
1 gradation
=0.462 mm (3 dots)
Only when using the bar code
change label with pre-feed area.
(This adjustment cannot be made
on the Variable Length Label.)
NOTES:
1. When a commodity name position is adjusted, an address position will move automatically.
2. When entering the other label format #, fine adjust values are initialized.
3. Selecting label format numbers other than those provided in Table 2 results in an error.
4. When selecting a variable length label format, rectangles are printed instead of print items
when test printing.
5. Pressing the
6. Be sure to press the
is selected.
Select the print format # which
allocates the label format #
0
by the
NEXT PLU
On-demand
Select "SENSIBILITY ADJUST"
by pressing the
◇
key.
When Batch Printing with backing paper is
selected, the sensitivity of the label sensor will
be set by pressing the
SET NEXT
issuing label.
◇
Enter the correct label feed
value.
(Range: 0 to 199)
Enter the correct value for
commodity name position.
(Range: 0 to 9)
Enter the correct value for
address position.
(Range: 0 to 15)
Enter the correct value for
pre-feed area.
(Range: 0 to 65)
◇
key allows you to select a print format number from 1 to 5.
key when a label format for batch printing with backing paper
SET NEXT
Enter the label format #.
key or
key.
FEED
SET
NEXT
key before
ENTER
ENTER
ENTER
ENTER
10-18
10.11 PRINT FORMAT
(Refer to table 2)
j
Is print
position
TEST
correct?
Incorrect
j
<MENU>
Page 2
j
<MENU>
j
j
Correct
CHANGE
PLU
PROG.
Main
ESC.
Advertisement
Table of Contents
