TEC EM1-31076 Owner's Manual page 20

8. REMOVAL AND REPLACEMENT OF RECEIPT/LABEL
4. Insert the tip of the receipt/label into the print head.
5. Align the two media guides with the right edge of the receipt/label.
Media Guide
6. Thread the receipt/label as shown below.
NOTE: Labels and receipts should be left-aligned as viewed from the front of the machine, and
always threaded in parallel with the media shaft and the print head. Failure to do this may
cause a paper jam or a skew feed.
7. Turn the head-up lever to the arrow indicating direction to set the print head in position.
(Label threading method)
Head-up Lever
Print Head
Backing Paper Stopper
8. Close the printer cover.
9. Finally press the Feed key to confirm that the labels/receipts are loaded correctly.
8. REMOVAL AND REPLACEMENT OF RECEIPT/LABEL
(Receipt threading method)
Label
Winding Roll
Head-up Lever
8- 2
Media Guide
Receipt