Denon PMA-60 Owner's Manual page 58

Contents Connections
o Sound is distorted or interrupted, or noise occurs
Symptom
Sound is distorted or
0
interrupted, or noise
0
occurs.
0
0
0
0
Sound is interrupted during
0
playback of music from a
computer.
o Desired sound does not come out
Symptom
No sound comes out of a
0
specific speaker.
0
The left and right of stereo
0
sound is reversed.
Set values are not reflected
0
in "Bass", "Treble" and
"Balance".
Headphone volume is low.
0
Front panel Display
Playback
Adjust to an appropriate volume level on this unit and the connected devices.
Place the device connected via Bluetooth closer to this unit.
Place this unit away from microwaves, wireless LAN devices, etc.
Turn off and on power to Bluetooth devices.
Turn down the volume of the playback device connected to the AUX connector.
Switch "H/P AMP Gain" to "High" if using headphones with high impedance or low sensitivity.
During playback of music from the computer, do not run any applications other than the player software.
Check that speaker cables are properly connected.
Set the left/right volume balance using "Balance" in the setup menu.
Check whether the left and right speakers are connected to the correct speaker terminals.
Set "Off" to the "Source Direct".
Switch "H/P AMP Gain" to "High" if using headphones with high impedance or low sensitivity.
Rear panel
Settings
Cause / Solution
Cause / Solution
58
Remote
Tips Appendix
Page
Page
Index
29
－
－
－
－
51
－
20
51
21
51
51