Denon PMA-60 Owner's Manual page 51

Contents Connections
Source Direct
Sets Source Direct Mode. The audio signal is not passed through the
sound quality adjustment circuits (Bass, Treble, Balance). This provides
playback that is more faithful to the original sound, but disables sound
quality adjustment.
Off
Disable source direct function.
(Default):
Playback sound is closer to the source
On: sound. Tone adjustments (Bass, Treble,
Balance) are disabled.
Bass
Adjusts the bass sound.
–8dB – +8dB (Default : 0dB)
Treble
Adjusts the treble sound.
–8dB – +8dB (Default : 0dB)
Balance
Use o p to adjust the left/right volume balance.
Front panel Display
Playback Settings
H/P AMP Gain
Set the gain of the headphone amplifier. Set this according to the
impedance of the connected headphones. It is recommended that this is
set on the "Low" side if the headphones have low impedance and on the
"High" side if they have high impedance.
Low:
Mid
(Default):
High:
NOTE
0 The headphone volume varies depending on the "H/P AMP Gain" setting.
Decrease the volume or mute the audio first if changing this setting while listening
to audio.
51
Rear panel
Tips
Set the gain of the headphone amplifier to
"Low". Set if the volume is too high when
the gain setting is "Mid".
Set the gain of the headphone amplifier to
"Mid".
Set the gain of the headphone amplifier to
"High".Set when there is insufficient
volume, even when the gain setting is
"Mid".
Remote Index
Appendix