Denon PMA-60 Owner's Manual page 39

Contents Connections
o Audio signals that can be played back
See "D/A Converter" (v p. 63).
NOTE
0 Perform operations such as playback and pause on the computer. At this time, you
cannot perform operations with buttons on this unit or the remote control.
0 You can also control the volume and equalizer on the computer. Enjoy playing
music at the desired volume.
0 When this unit is functioning as a D/A converter, sound is not output from the
computer's speakers.
0 If the computer is disconnected from this unit while the computer music playback
software is running, the playback software may freeze. Always exit the playback
software before disconnecting the computer.
0 When an error occurs on the computer, disconnect the USB cable and restart the
computer.
0 The sampling frequency of the music playback software and sampling frequency
displayed on this unit may differ.
0 Use a cable that is 10 ft (3 m) or less to connect to the computer.
Front panel Display
Playback Settings
Listening to music via a digital
connection (COAXIAL/OPTICAL-1/
OPTICAL-2)
1
Press q to switch the input source to "COAXIAL",
"OPTICAL-1" or "OPTICAL-2".
The digital audio signal that is being input is shown as follows in the
display.
2
Play back music on the connected device.
The speakers output music from the connected device.
39
Rear panel
Tips
or
(xxxx is the sampling frequency.)
If the sampling frequency cannot be detected, "Unlocked" will be
0
displayed.
"Unsupported" is displayed when audio signals that are not
0
supported by this unit are input.
Remote Index
Appendix
or