Impex SM-5276 Owner's Manual page 18

Upper Cable assembly instruction Step-12B
A.) Attach a Small Pulley to the opening on left Upper Side Frame (#7). Secure the Small Pulley with
one M10 x 2 ¾" Allen Bolts (#97), two Ø ¾" Washers (#107), and one M10 Aircraft Nut (#110).
B.) Draw the Cable under the Small Pulley and then pull up.
C.) Attach a Small Pulley to the next opening. Secure it with one M10 x 2 ¾" Allen Bolts (#97), two Ø
¾" Washers (#107), and one M10 Aircraft Nut (#110). Draw the Cable around the top of the Small
Pulley.
D.) Attach a Cross-over Swivel Pulley Bracket (#10) to the right Upper Side Frame (#7). Secure it with
four M8 x ⅜" Allen Bolts (#101) and four Ø ⅝" Washers (#106).
E.) Attach a Pulley to the Swivel Pulley. Secure it with one M10 x 1 ¾" Allen Bolt (#93), two Ø ¾"
Washers (#107), and one M10 Aircraft Nut (#110).
F.) Draw the Cable around the top of the Pulley and through to the outside of Swivel Bracket. Attach a
Cable Roller (#42) to the left Swivel Bracket. Secure it with one M8 x 1 ⅝" Allen Bolt (#102), two Ø
⅝" Washers (#106), and one M8 Aircraft Nut (#109).
G.) Re-install the Ball Stopper; Big Washer, and the U-shaped Connector to the end of the Cable.
H.) Connect a Single Handle (#79) to the end of the Cable with a Hook (#73). Secure the Hook to the
U-shaped Connector with one M10 x 1 ⅛" Allen Bolt (#92) and M10 Aircraft Nut (#110).
©IMPEX INC.
17
www.marcypro.com