Impex SM-5276 Owner's Manual page 14

Upper Cable assembly instruction Step-12
A.) Attach one Cross-over Swivel Pulley Bracket (#10) to right Upper Side Frame (#7). Secure it
with four M8 x ⅜" Allen Bolts (#101) and four Ø ⅝" Washers (#106).
B.) Attach a Pulley (#62) to the right Swivel Bracket and secure it with one M10 x 1 ¾" Allen Bolt
(#93), two Ø ¾" Washers (#107), and one M10 Aircraft Nut (#110).
C.) Remove the U-shaped Connector, Big Washer, and Ball Stopper from one end of the 266"
Upper Cable (#47).
D.) Insert the open end of Upper Cable through the right Swivel Bracket. Draw the Cable over the
Pulley and pull it toward the back of the machine.
E.) Attach a Cable Roller (#42) to the right Swivel Bracket. Secure it with one M8 x 1 ⅝" Allen Bolt
(#102), two Ø ⅝" Washers (#106), and one M8 Aircraft Nut (#109).
F.) Attach a Small Pulley (#63) to the opening on the right Upper Side Frame (#7). Secure it with
one M10 x 2 ¾" Allen Bolt (#97), two Ø ¾" Washers (#107), and one M10 Aircraft Nut (#110).
Draw the Cable around the top of the Small Pulley.
G.) Attach another Small Pulley to the opening next to the Small Pulley installed in Procedure F.
Secure it with one M10 x 2 ¾" Allen Bolt (#97), two Ø ¾" Washers (#107), and one M10
Aircraft Nut (#110). Draw the Cable under the Small Pulley to an open pulley shaft.
H.) Connect a Single Handle (#79) to the Cable End under the right Swivel Pulley Bracket with a
Hook (#73). Secure the Hook to the U-shaped Connector with one M10 x 1 ⅛" and one M10
Aircraft Nut (#110).
©IMPEX INC.
13
www.marcypro.com