Honeywell Fire-Lite Alarms MS-9600 Manual page 110

Programming
110
Pressing 3 while viewing Zone Setup screen will display the following screen:
SPEC PURPOSE ZONE
1=PAS 97
2=PRE-SIGNAL 98
3=FUTURE 99
Zones 97, 98 and 99 can be programmed for normal zone operation or for special
purpose applications. In the above illustration, the three zones are shown Off,
which means they can be programmed to function in the same manner as all other
zones, by assigning them to input and output devices in the Programming Zone
Assignment Screen.
Pressing 1 will cause the display to change to PAS 97 On. Each press of the 1 key
will cause the display to toggle between PAS 97 On and PAS 97 Off. When Zone 97
is programmed On, a PAS (Positive Alarm Sequence) activation of any device will
cause Zone 97 to activate. By assigning Zone 97 to a control module in the
Programming Zone Assignment Screen, an output device connected to the control
module can be used to indicate a PAS condition in the control panel. Do not assign
Zone 97 to a Notification Appliance Circuit when using this zone to indicate a PAS
condition.
Pressing 2 will cause the display to change to Pre-signal 98 On. Each press of the 2
key will cause the display to toggle between Pre-signal 98 On and Pre-signal 98
Off. When Zone 98 is programmed On, a Pre-signal activation of any device will
cause Zone 98 to activate. By assigning Zone 98 to a control module in the
Programming Zone Assignment Screen, an output device connected to the control
module can be used to indicate a Pre-signal condition in the control panel. Do not
assign Zone 98 to a Notification Appliance Circuit when using this zone to indicate
a Pre-signal condition.
Zone 99, in special purpose mode, is reserved for future use and has no effect.
Maintenance Programming Level
OFF
OFF
OFF
Disable Screen
MS-9600 PN 51335:E1 2/14/08