Table of Contents
Advertisement
4. If the transducer to be used is programmed in the FCV-30, choose Model number in
the Setting method box, and choose the model in LF or HF box.
Note: Change the tap inside the ETR-30N according to the character which appears next to
"TAP": A to D displayed beneath the frequency. For details, see the Operator's
Manual for the ETR-30N.
5. If the transducer is not programmed in the FCV-30, choose Manual in the Setting
method box, and enter the frequency manually by the keyboard or use ◄ or ► button
(Setting range: 25 to 220 kHz).
6. Click the Apply button and then the OK button.
Network Setting
1. Hold down [F1] and [F4] key and click the System in the ETR window.
2. Click Network to show the ETR Network window.
3. Choose the Host name from the drop-down menu according to ETR-30N setting.
Choose SOUNDER when Host name of ETR-30N is 0, and choose SOUNDER 1 when Host
name of ETR-30N is 1, etc. For details, see the Operator's Manual for ETR-30N.
4. Click the Apply button and then the OK button.
Note: After changing setting, reboot ETR-30N.
3. SYSTEM SETTINGS AFTER INSTALLATION
21
Advertisement
Table of Contents
