[Initialize All] - Panasonic PT-VMZ60 Operating Instructions Manual

f The [FILTER COUNTER] screen is displayed.
[FILTER COUNTER]
[TIMER]
[FILTER COUNTER RESET]
Setting [TIMER]
If you want to regularly clean/replace the air filter, set its cycle time. When the air filter usage time reaches the set
time, a message of "FILTER COUNTER has reached the set time" prompting you to clean/replace the air filter is
displayed on the projection screen.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [TIMER].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[1000H] - [20000H]
Setting [FILTER COUNTER RESET]
Resets the usage time of the air filter.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [FILTER COUNTER RESET].
4) Press the <ENTER> button.
5) When the confirmation screen is displayed, press qw to select [OK] and then press the <ENTER>
button.
f The display of [FILTER COUNTER] changes to "0H".

[INITIALIZE ALL]

Return various setting values to their factory default settings.
1) Press as to select [INITIALIZE ALL].
2) Press the <ENTER> button.
3) When the [INITIALIZE ALL] screen is displayed, press qw to select [OK] and then press the <ENTER>
button.
4) When the power off confirmation screen is displayed after a while, press the <ENTER> button.
f The operations except for powering off are disabled.
Note
f When the [SECURITY] menu → [PASSWORD] is set to [ON], the [PASSWORD] screen will be displayed after selecting [INITIALIZE ALL]
and pressing the <ENTER> button. Enter the security password set for the projector and continue your desired operation.
f The projector will enter the standby status to reflect the setting values when [INITIALIZE ALL] is executed.
f Even if [INITIALIZE ALL] is performed, the settings of the following items cannot be initialized.
g [STANDBY MODE]
g [RS-232C]
g [FILTER COUNTER]
g [NETWORK]
f To initialize the settings of [NETWORK], perform the [NETWORK] menu → [INITIALIZE].
f When [INITIALIZE ALL] is executed, the [INITIAL SETTING] screen is displayed when the projection starts next time.
Chapter 4 Settings - [PROJECTOR SETUP] menu
Displays the usage time of the air filter.
Sets the cleaning/replacement cycle of the air filter.
Resets the air filter usage time.
Select not to display the message.
Select to display the message. You can set the cleaning/replacement cycle of the air filter.
ENGLISH - 91