Switching On The Projector; When The Initial Setting Screen Is Displayed - Panasonic PT-VMZ60 Operating Instructions Manual

Note
f While the power indicator <ON (G)/STANDBY (R)> lights in orange, the fan is running to cool the projector.
f For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks in red.
f The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lights/blinks in red). Refer to "Power
consumption" (x page 144) for the power consumption.
f The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.

Switching on the projector

Before switching on the projector, make sure all the other devices are correctly connected (x page 36).
Remove the lens cap beforehand.
1) Connect the power cord to the projector.
2) Connect the power plug to an outlet.
f The power indicator <ON(G)/STANDBY(R)> lights/blinks, and the projector will enter the standby mode.
3) Press the power <v/b> button.
f The power indicator <ON(G)/STANDBY(R)> lights in green and the image is soon projected on the screen.
Attention
f Be sure to remove the lens cap before starting projection.
Note
f When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], it takes longer for the projection to
start after the power is turned on, compared to when set to [NORMAL].
f When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] is set to [ON], and the power is turned on before
the specified time elapses after the projector enters the standby mode, an image will be projected approximately one second after the power
is turned on.
The specified time is a time set in the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] → [VALID PERIOD].

When the initial setting screen is displayed

When the projector is switched on for the first time after purchase or the [PROJECTOR SETUP] menu →
[INITIALIZE ALL] is executed, the [INITIAL SETTING] screen is displayed after the projection starts. Set them in
accordance with circumstances. In other occasions, you can change the settings by menu operations.
When the [INITIAL SETTING] screen is displayed, you can return to the previous screen by pressing the
<MENU> button or <RETURN> button.
Note
f When the projector is used for the first time, in order to clearly display the menu screen, it may be necessary to adjust the focus lever and
the zoom lever in the projection lens area of the projector (x page 26). For details, refer to "Adjusting the focus, zoom, and lens shift"
(x page 50).
Initial setting (display language)
Select the language to show on the screen.
After the initial setting, you can change the display language from the [LANGUAGE] menu.
1) Press asqw to select the display language.
44 - ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector
2)
1)
3) 3)