[Initialize All] - Panasonic PT-FX500 Operating Instructions Manual

f The setting of the date and time will be completed.
Setting the date and time automatically
1) Press as to select [DATE AND TIME].
2) Press the <ENTER> button.
f The [DATE AND TIME] screen is displayed.
3) Press as to select [ADJUST CLOCK].
4) Press the <ENTER> button.
f The [ADJUST CLOCK] screen is displayed.
5) Press as to select [NTP SYNCHRONIZATION], and press qw to change the setting to [ON].
6) Press as to select [OK], and press the <ENTER> button.
f The setting of the date and time will be completed.
Note
f To set the date and the time automatically, the projector must be connected to the network.
f If synchronization with the NTP server fails just after [NTP SYNCHRONIZATION] is turned [ON], [NTP SYNCHRONIZATION] will return to
[OFF]. Also if [NTP SYNCHRONIZATION] is turned [ON] while the NTP server is not set, [NTP SYNCHRONIZATION] will return to [OFF].
f Access the projector via a web browser to set the NTP server. Refer to "[Adjust clock] page" ( x page 124) for details.
f The [TIME ZONE] setting is reset to the factory default when [INITIALIZE ALL] is executed from the [PROJECTOR SETUP] menu ( x page
97). However, the date and the time based on the local date and the time setting (Coordinated Universal Time, UTC, Universal Time,
Coordinated) will be maintained without being initialized.

[INITIALIZE ALL]

Return various setting values to their factory default settings.
1) Press as to select [INITIALIZE ALL].
2) Press the <ENTER> button.
f The [INITIALIZE ALL] screen is displayed.
3) When the confirmation screen is displayed, press qw to select [OK] and then press the <ENTER>
button.
f The [NOW INITIALIZING...] screen is displayed and then the [POWER OFF.] screen will be displayed.
4) Press the <ENTER> button.
f The operation of other buttons is disabled.
f The initial setting (display language) screen will be displayed when the projector is switched on the next
time.
Note
f The projector will enter the standby status to reflect the setting values when [INITIALIZE ALL] is executed.
f When [INITIALIZE ALL] is executed, [STANDBY MODE], [EMULATE], [FILTER COUNTER] and the setting values of [NETWORK] cannot be
returned to the factory default values.
For details about the initialization of [NETWORK], please refer to [NETWORK] → [INITIALIZE]. (
Chapter 4 Settings — [PROJECTOR SETUP] menu
Æ page 104)
ENGLISH - 97