Table of Contents
Advertisement
Chapter 3 Basic Operations - Operating with the remote control
Note
f The projector status can also be displayed using the menu operation. Refer to the [PROJECTOR SETUP] menu → [STATUS] (x page 83)
for details.
Using the ECO management function
Display the setting screen relating to ECO management.
button
1)
Press the <ECO> button.
Note
f Refer to the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] (x page 84) for details.
Setting the ID number on the remote control
When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector
individually using a single remote control, if a unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID
ALL> button on the remote control. Also, you can control a projector by pressing the <ID ALL> button on
the remote control even if you do not know the projector ID.
button
1)
Press the <ID SET> button on the remote control.
2)
Within five seconds, press and set the one-digit or two-digit ID number set on the projector body
using the number (<0> - <9>) buttons.
f If you press the <ID ALL> button, you can control the projectors regardless of the ID number setting of the
projector.
Attention
f Since the ID number of the remote control can be set without the projector, do not press the <ID SET> button on the remote control
carelessly. If the <ID SET> button is pressed and no number (<0> - <9>) buttons are pressed within five seconds, the ID number returns to
its original value before the <ID SET> button was pressed.
f The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control is left with dead
batteries. Set the same ID number again when the batteries are replaced.
Note
f When the ID number of the remote control is set to [0], the projectors can be controlled regardless of the ID number setting on the projector,
same as when set to [ALL].
f Set the ID number of the projector from the [PROJECTOR SETUP] menu → [PROJECTOR ID]. (x page 83)
PT-VMZ50
STATUS
SIGNAL
NAME
FREQUENCY
RUNTIME
PROJECTOR
LIGHT RUNTIME
CONTINUOUS LIGHTING TIME
PROJECTOR SETUP
SERIAL NUMBER
PROJECTOR
RETURN
SELECT
button
1/2
NO SIGNAL
0.00kHz/ 0.00Hz
0 H
1 H
0 H
000000000
ASSIGNED FUNCTION:
DISABLE
ENGLISH - 57
Advertisement
Chapters
Table of Contents
