Table of Contents
Advertisement
Chapter 6 – Getting Started
After powering up your device, refer to the following sources for help configuring and using your device.
mPower Models
If your device uses the mPower platform, getting started information is in
available through your model's page at
mLinux Models
If your device uses the mLinux platform, getting started information is at
http://www.multitech.net/developer/software/mlinux/getting-started-with-conduit-mlinux/
Dual Carrier Firmware for Cellular Radio
This device uses a cellular radio with dual carrier firmware meaning that it can be used on different carrier
networks (not simultaneously). The device can be used on either the Verizon or AT&T/other networks. The device
is configured for AT&T/others by default. The device is configured for Verizon by default.
To check that your device is configured for the desired network:
AT#FWSWITCH?
If response is:
#FWSWITCH: 0
The device is configured for AT&T/other networks.
If response is:
#FWSWITCH: 1
The device is configured for Verizon.
To switch carrier networks:
From AT&T to Verizon:
AT#FWSWITCH=1,1
From Verizon to AT&T:
AT#FWSWITCH=0,1
Note:
For the Link status (LS) LED to function, you must issue the command AT#GPIO=1,0,2 any time you use
the firmware switch command (AT#FWSWITCH=0 or AT#FWSWITCH=1).
®
Conduit
AP MTCAP2-LNA3-915-042x-POE and MTCAP2-915-042x-POE User Guide
https://www.multitech.com/brands/multiconnect-conduit-ap
mPower Software Guide
GETTING STARTED
(S000727),
19
Advertisement
Table of Contents
