Table of Contents
Advertisement
SPECIFICATIONS AND HARDWARE INFORMATION
Resetting the Device
You need:
A pin, paperclip, or similar thin object that can fit into the reset hole
To reset the device:
1.
Find the hole labeled RESET. The reset button is recessed into the case.
2.
Use the pin to press and release the RESET button as follows:
Reset options:
Note:
The device reboots when restoring settings.
For more information about commissioning mode, consult the mPower Software Guide or mlinux developer resources.
Refer to
Documentation Overview
Power Measurements
MTCAP2-915-042
Note:
Multi-Tech Systems, Inc. recommends that you incorporate a 10% buffer into the power source
when determining product load.
Maximum Power: The continuous current during maximum data rate and at LoRa Max power setting
Tx Pulse: The average peak current during LoRa transmission.
Inrush Charge: The total inrush charge at power on.
Voltage
Sleep Mode
Current
5 VDC
N/A
38 VDC POE
N/A
56 VDC
N/A
10
To reboot, press RESET for less than 3 seconds.
To reboot and restore user-defined defaults (if previously set), press RESET for 3 to 29
seconds.
To reboot, restore factory settings, and erase user-defined defaults, press RESET for 30
seconds or longer.
The device restarts in commissioning mode. The system automatically removes all user
accounts.
Enter a new username and password to create your new administrative account. (Refer to
User Accounts in the appropriate software guide for details on username and password
requirements.)
for details.
Cellular Call
Box
Connection
No Data, OR
IDLE Measure,
with no Radio
137 mA
61 mA
40 mA
®
Conduit
AP MTCAP2-LNA3-915-042x-POE and MTCAP2-915-042x-POE User Guide
Average
TX Pulse Peak
Measured
Current for no
Current at
radio model
Maximum
Power
452 mA
584 mA
126 mA
272 mA
106 mA
224 mA
Total Inrush
Total Inrush
Charge
Charge
Duration
0.962 mC
1.69 mS
0.127 mC
10.6 mS
0.130 mC
10.3 mS
Advertisement
Table of Contents
