Table of Contents
Advertisement
SETTING UP HARDWARE
Chapter 5 – Setting Up Hardware
Installing a SIM Card
Models with cellular capability have a micro SIM slot, you'll need a micro (3FF) SIM card from your network
provider.
Note:
-LNA3 models work on both Verizon and AT&T networks. The device detects the carrier based on
your SIM card.
To install the SIM card:
With the contact side facing down, align the notched edge as shown on the following image and slide the
SIM card completely into the SIM holder.
Removing a SIM Card
To remove the SIM card, push the SIM card in. The device ejects the SIM card.
Attaching the Antenna
To connect the antenna:
Finger-tighten the antenna to the SMA antenna connector on your device.
Cabling the Device
To cable the device:
Note:
If using PoE to power your device, refer to
Step 2.
1.
Connect the Ethernet cable to the Ethernet port on the device.
2.
Connect the power supply to the MTCAP's power jack and plug it into an electrical outlet.
When the operating system is fully loaded, the STATUS LED blinks.
18
Power over Ethernet (PoE)
®
Conduit
AP MTCAP2-LNA3-915-042x-POE and MTCAP2-915-042x-POE User Guide
for additional information and skip
Advertisement
Table of Contents
