Wps - TP-Link Archer C20 User Manual

Chapter 4
2. Go to
3. Configure the basic settings for the wireless network and click Save.
• Wireless
• Wireless Network Name
must be assigned to all wireless devices in your network.
• Mode
• Channel
channel is set to Auto. It is not necessary to change the wireless channel unless you
notice interference problems with another nearby access point.
• Channel Width
necessary to change the wireless channel unless you notice interference problems
with another nearby access point. If you select auto, then AP will choose the best
channel automatically.
• Enable SSID Broadcast
name (SSID).
4. 4. 2.
WPS (Wi-Fi Protected Setup) can help you to quickly and securely connect to a network.
This section will guide you to add a new wireless device to your router's network quickly
via WPS.
Note:
The WPS function cannot be configured if the wireless function of the router is disabled. Please make sure the wireless
function is enabled before configuration.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
3. Follow one of the following three methods to connect your client device to the
router's Wi-Fi network.
Downloaded from ManualsNet.com
Wireless > Basic Settings.
- Enable or disable wireless network.
- Enter a value of up to 32 characters. The same Name (SSID)
- You can choose the appropriate "Mixed" mode.
- This field determines which operating frequency will be used. The default
- This field determines which operating frequency will be used. It is not
- If enabled, the router will broadcast the wireless network

WPS

Wireless > WPS.
search engine
Configure the Router
24