SOYO Super 7 SY-5EMA+ User's Manual & Technical Reference page 38

Hardware Setup
Step 16. Power On
You have now completed the hardware installation of your
Motherboard successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the
system is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot
up sequence is completed. Then push the RESET button and
press <DEL> key again at the beginning of boot-up, during
diagnostic checks.
Repeat this operation until you get the following screen.
3. The BIOS Setup screen appears:
ROM PCI/ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
STANDARD CMOS SETUP INTEGRATED PERIPHERALS
BIOS FEATURES SETUP SUPERVISOR PASSWORD
CHIPSET FEATURES SETUP USER PASSWORD
POWER MANAGEMENT SETUP IDE HDD AUTO DETECTION
PNP/PCI CONFIGURATION SAVE & EXIT SETUP
LOAD SETUP DEFAULTS EXIT WITHOUT SAVING
LOAD BIOS DEFAULTS
↑ ↓ → ←
Esc : Quit
F10 : Save & Exit Setup (Shift) F2
Time, Date, Hard Disk Type...
You are now ready to configure your system with the BIOS setup
program. Go to Chapter 3: BIOS SETUP
All manuals and user guides at all-guides.com
SY-5EMA+ V1.0
: Select Item
: Change Color
33