SOYO Super 7 SY-5EMA+ User's Manual & Technical Reference page 28

Hardware Setup
l
MEMORY CONFIGURATION
This Motherboard features 3 x DIMM Banks for 168-pin 3.3V
unbuffered DIMM modules
Your board comes with three DIMM sockets, providing support for
up to 768MB of main memory using DIMM modules from 8MB to
256MB. For 66MHz host bus CPUs use 12ns or faster DIMM
modules; for 83MHz or faster host bus CPUs use 8ns modules.
Memory configuration Table
MEMORY
CONFIGURATION
DIMM 1
RAM Type EDO/SDRAM
Single RAM 8/16/32/64/128/
Module Size (MB)
Step 7. IDE Device Installation (HDD, CD-ROM)
This Motherboard offers two primary and secondary IDE device
connectors (IDE1, IDE2.) It can support up to four high-speed HDD
or CD-ROM.
Connect one side of the 40-pin flat cable to the IDE device (HDD or
CD-ROM) and plug the other end to the primary (IDE1) or secondary
(IDE2) directionally keyed IDE connector on the Motherboard.
This Motherboard can support up to four HDDs.
Step 8. Floppy Drive Installation
The system supports 5 possible floppy drive types: 720 KB, 1.2 MB,
1.44 MB, 2.88 MB, and LS-120. In addition, this Motherboard
supports a 3-mode (720KB/1.25MB/1.44MB) floppy commonly used
in Japan.
Connect one side of the 34-pin flat cable to the floppy drive and plug
the other end to the floppy drive connector on the Motherboard.
This Motherboard can support up to 2 floppy drives.
All manuals and user guides at all-guides.com
DIMM Banks
DIMM 2
EDO/SDRAM
8/16/32/64/128/
256 256
23
SY-5EMA+ V1.0
DIMM 3
EDO/SDRAM
8/16/32/64/128/
256