Chapter 4
• Rate
• Run Time
• Transmit
• Receive
Click
Start/Stop
4. 5.
4. 5. 1.
Simple Network Management Protocol (SNMP) is a popular network monitoring and
management protocol.
1. Visit http://tplinkap.net, and log in using the password you created.
1. Go to
• SNMP Agent
want to have remote control through SNMPv1/v2 agent with MIB-II. Select the radio
button before Disable will disable this function. The default setting is Disable.
• SysContact
• SysName
• SysLocation
Note:
If you are not familiar with the setting items on this page, it's strongly recommended to keep the provided default values;
otherwise it may result in lower wireless network performance.
• Get Community
Device's SNMP information. The community name can be considered a group
password. The default setting is "public".
• Get Source
that can read information from this 'get' community device.
Downloaded from
ManualsNet.com
- The Throughput unit.
- How long this function is running.
- Wireless transmit rate information.
- Wireless receive rate information.
to start or stop wireless throughput monitor.
System Tools
SNMP
System Tools
> SNMP.
- Select the radio button before Enable will enable this function if you
- The textual identification of the contact person for this managed node.
- An administratively-assigned name for this managed node.
- The physical location of this node.
- Enter the community name that allows Read-Only access to the
- Get source defines the IP address or subnet for management systems
search engine
Configure the Access Point
39