Calibration Procedure; Adjusting The Speed Sensor - Spirit XT185 Owner's Manual

CALIBRATION PROCEDURE

1. Remove the safety key
2. Press and hold down the Start and Speed + buttons and replace the safety key. Continue
to hold the Start and Fast key until the window displays "Factory settings", then press the
Enter key.
3. You will now be able to set the display to show Metric or English settings (Miles vs.
Kilometers). To do this, press the up or down key to show which you want, then press Enter.
4. Make sure the wheel size diameter is 2.30 then press Enter
5. Adjust the minimum speed (if needed) to 0.5 and then press Enter
6. Adjust the maximum speed (if needed) to 10.0 and then press Enter
7. Adjust the maximum elevation (if needed) to 10 and then press Enter
8. Grade return – On (This allows the incline to return to zero when stop is pressed. For sale in
Europe, EU standards require this to be off)
9. Press Start to begin calibration. The process is automatic; the speed will start up
without warning, so do not stand on the belt.

ADJUSTING THE SPEED SENSOR

If the calibration does not pass you may need to check the speed sensor alignment.
1. Remove the motor cover hood by loosening the 4 screws that hold it
in place (you do not need to remove them completely).
2. The speed sensor is located on the left side of the frame, right next to
the front roller pulley (the pulley will have a belt around it that also goes
to the motor). The speed sensor is small and black with a wire
connected to it.
3. Make sure the sensor is as close as possible to the pulley without
touching it. You will see a magnet on the face of the pulley; make sure
the sensor is aligned with the magnet. There is a screw that holds the
sensor in place that needs to be loosened to adjust the sensor.
Re-tighten the screw when finished.
MAINTENANCE MENU
1. Press and hold the Start, Stop and Enter key at the same time, until the display shows "Engineering
mode" (it may say maintenance menu, depending on version). Press the Enter key.
2. You can now scroll through the menu using the + and - keys. Use the Stop key to return to previous
menu selection. The menu selections are:
A. Key Test - Tests that each key is functioning properly
B. Display - Test the LCD display segments are all lighting properly
C. Functions
Sleep Mode - Allows you to turn off the sleep mode. Console will stay on all the time unless
I.
power is turned off.
II. Pause Mode - When the console is paused during a program this will allow you to keep the
console paused indefinitely instead of 5 minutes.
III. Odometer - Allows you to reset the odometer
IV. English - When enter is pressed allows you to change the settings for data to metric.
Motor Test - For service personnel only when troubleshooting motor problems.
V.
VI. Beep - Allows you to disable the speaker so there is no beeping.
D. Security - Allows you to lock the keypad so the treadmill cannot be used. Press Enter to change
setting (also called child lock).
E. Factory Settings - For factory use only
XT185 Treadmill 24