Drystar 5500, Drystar 5503 | Advanced Operation (key-operator mode) | 23
Accessing the Change settings menu
1. Press the Key-operator key to enter the Key-operator mode.
2. On the Key-operator main menu, press the Down key twice, followed by
the Confirm key to select 'Change settings'.
The 'Change settings' screen is displayed:
3. Press the Escape key to return to the Key-operator main menu.
4. Press the Escape key to quit the Key-operator mode.
When the settings have been changed, the 'accept modifications' window
is displayed:
Each time the settings have been changed and confirmed, an automatic
back-up of the new configuration is made on the hard disk. You will also
be asked to create a back-up floppy.
Select 'yes' if you wish to accept the changed settings. Press the Confirm
key.
Select 'no' if you do not wish to accept the changed settings. Press the
Confirm key. You will return to the Main menu.
After selecting 'yes', the 'Update back-up' screen is displayed:
Note: If the printer has not yet been installed, the 'printer
installation wizard' should be executed first. In this case, the
following screen is displayed:
2900J EN 20180320 1448