Inner Frame - Braun Infusomat Space Service Manual

3.10 Inner frame

EN Infusomat® Space 6.0
Disassembly / Assembly
Designation
Lock bolt drive ISP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3452 1429
Linear poti ISP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3452 1056
Pressure adjustment unit ISPS . . . . . . . . . . . . . . . . . . . 3452 1445
(spring holder, pressure springs, adjusting screw
adjusting nut, bracket, bracket locking)
Pump frame ISP, without motor . . . . . . . . . . . . . . . . . 3452 1402
Pump drive motor ISP . . . . . . . . . . . . . . . . . . . . . . . . . . 3452 1410
Lock bolt ISP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3452 1496
Inner frame ISP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3452 1437
Bracket locking and screws
(see „Service Parts and Screw Kit" ➨ pg. 3 - 7)
Note
Please pay attention to the corresponding notes during assembly
and installation (see „Inner Frame" ➨ pg. 3 -
Disassembly
1. Carefully press two bracket lockings
the front and rear out of the inner frame
*
Item 3).
2. Push the bracket (Fig.: 3 - 24 / Item
tension, unhook from the inner frame and remove it together
with the pressure adjustment unit
3. Press the pump frame guide (6 mm straight pin)
/ Item 8) in longitudinal direction out of the linear bearings
of the pump frame and the inner frame holders and remove
the pump frame from the inner frame.
*
Do not reuse the bracket lockings
3
Order No.
42).
(Fig.: 3 - 24 / Item 10) at
(Fig.: 3 - 24 /
6) forward against spring
(Fig.: 3 - 24 / Item 7).
(Fig.: 3 - 24
3 - 25