Parameter Mode - Mitsubishi Electric MELSERVO MR-HP30KA Instruction Manual

4 DISPLAY SECTION AND OPERATION SECTION OF THE CONVERTER UNIT

4.5 Parameter mode

The following example gives the operation procedure after power-on for use of the regenerative brake
options (MR-RB137).
To shift to the next parameter, press the "UP"/"DOWN" button.
When changing the parameter No.0 setting, change its set value, then switch power off once and switch it
on again to make the new value valid.
Downloaded from ManualsNet.com search engine
Press MODE three time
The parameter number is displayed.
Press UP or DOWN to change the number.
Press UP twice
The set value of the specified parameter
number flickers.
Press UP fourth
During flickering, the set value can be change.
Use UP or DOWN .
( 4: MR-RB137 (3 pcs.) are used)
Press SET to enter.
4 - 6