Toshiba nv Series Instruction Manual page 74

Chapter 4 Settings
Add slave devices to the Scanlist
5
Select the slave node (3, 1794-ADN DeviceNet Flex I / O Adapter) on the Scanlist tab screen, and click Add.
At this time, the bit strobe and polling Rx (receive size) / Tx (transmit size) setting screen is displayed. Set the
size here and click OK to add the slave node to the Added area. Even if the size is not set, clicking OK or
Cancel will add the slave node to the Added area.
Figure 4-13 Add slave node to Scanlist
58
6F8C1877